How To Change Code On Schlage Lock Without Programming Code References. To factory reset the schlage connect be468/be469 smart locks. The lock will flash green and beep once, and that means the operation is successful.

How To Change Code On Schlage Lock Without Programming from sa4.eatmytangerine.com

On the lock keypad, press and release the schlage button. But the lock only accepts 6 different user codes. Do not reset your lock unless you are able to locate the original programming code.

Press And Hold Down The Logo.

Enter same new programming code.enter your current programming code (6 digits) and wait for three orange lights from the schlage button and three beeps.enter “30” and hit the lock button.excellent job on removing the old codes now you need to enter a new code for yourself. About code how reset lock to programming schlage without keypad. If you have forgotten your programming code, you can restore the default codes.

While Holding The Schlage Button, Reattach The Battery Terminal.

Test your lock with one of your default codes, located on the back of this guide. On the interior assembly, remove the battery cover and then disconnect the batteries.; Press key 3 and wait for the schlage button to illuminate three orange lights and the lock beep three times.

Then Release It And Reconnect The Battery Within The Next 10 Seconds.

Disconnect the batteries then on the lock keypad press and release the schlage button. You can then change or delete codes as necessary from there. On the lock keypad, press and release the schlage button.

The Keypad Should Light Up.

The lock will flash green and beep once, and that means the operation is successful. How to change code on schlage lock without programming code. Do not reset your lock unless you are able to locate the original programming code.

You Have To Hunt Around On The Site For The Pdf, But It's There.

You might want to change your schlage code if you suspect someone has discovered the existing code. How to reset a schlage keypad lock (without programming code) step 1: Press and hold the schlage button again until you hear a beep.